SINCEN Dental XTCERA-compatible zirconia milling burs with DLC (diamond-like carbon) coating for dry milling of pre-sintered and multi-layer zirconia. Designed for XTCERA milling machines with a 4mm smooth shank (collet-clamped). Three configurations cover single crowns, bridges, full-arch frameworks, and implant abutments.
| Compatible Machines | XTCERA (4mm Shank), XTCERA milling machine |
|---|---|
| Interface Type | φ4mm Smooth Shank |
| Material Category | Zirconia |
| Configurations | 3 |
| Order No | Specification | Head Ø | Neck | Shank | Length | Inquiry |
|---|---|---|---|---|---|---|
| φ0.6mm | φ0.6×TL10×φ4×L50 | 0.6 | 10 | 4 | 50 | 1 |
| φ1mm | φ1×TL16×φ4×L50 | 1 | 16 | 4 | 50 | 1 |
| φ2mm | φ2×TL16×φ4×L50 | 2 | 16 | 4 | 50 | 1 |
φ2mm suits roughing and bulk material removal. φ1mm suits intermediate material removal and occlusal anatomy. φ0.6mm suits fine detail and tight internal contours.
These burs are not for metal, wet milling, or fully sintered zirconia.
They use a φ4mm smooth shank (collet-clamped), not a threaded shank. This matches the XTCERA (4mm Shank) milling machine spindle.
The DLC (diamond-like carbon) coating provides a hard, low-friction surface that helps reduce heat and material adhesion when dry milling pre-sintered and multi-layer zirconia.
These burs are compatible with XTCERA milling machines that use a 4mm smooth shank (collet-clamped) interface. Always verify your machine's spindle specification before ordering.
φ0.6mm is for fine detail and tight internal contours. φ1mm is for intermediate material removal and occlusal anatomy. φ2mm is for roughing and bulk material removal. Most zirconia workflows use a combination of diameters.
Watch for signs such as increased cutting noise, chipping on zirconia margins, longer milling time for the same geometry, or visible wear on the DLC coating. Replace when these signs appear to maintain restoration fit.
These are SINCEN Dental aftermarket burs manufactured to fit XTCERA (4mm Shank) machines. They are not produced by XTCERA. Lab-friendly wholesale pricing is available.
These burs are specified for dry milling of pre-sintered and multi-layer zirconia only. They are not designed for wet milling, metals, or fully sintered zirconia.