These Wieland compatible milling burs are designed for dry milling of pre-sintered and multi-layer zirconia in dental laboratories. With a DLC (diamond-like carbon) coating and φ3 mm smooth shank, they are available in three head diameters (φ0.6 mm, φ1 mm, φ2.5 mm) for single crowns, bridges, full-arch frameworks, and implant abutments.
| Compatible Machines | Wieland |
|---|---|
| Interface Type | φ3mm Smooth Shank |
| Material Category | Zirconia |
| Configurations | 3 |
| Order No | Specification | Head Ø | Neck | Shank | Length | Inquiry |
|---|---|---|---|---|---|---|
| φ0.6mm | φ0.6×TL10×φ3×L35 | 0.6 | 10 | 3 | 35 | 1 |
| φ1mm | φ1×TL16×φ3×L35 | 1 | 16 | 3 | 35 | 1 |
| φ2.5mm | φ2.5×TL20×φ3×L35 | 2.5 | 20 | 3 | 35 | 1 |
The φ2.5 mm bur is suited for roughing and bulk material removal in large frameworks. The φ1 mm bur works for semi-finishing and medium details, while the φ0.6 mm bur is for fine finishing, tight occlusal anatomy, and small restorations.
These burs are not for metals, glass ceramics, or wet milling; they are intended only for dry milling of pre-sintered and multi-layer zirconia in Wieland machines with a φ3 mm collet-clamped shank.
All three variants use a φ3 mm smooth shank, which is collet-clamped in compatible Wieland milling machines.
Yes, they have a DLC (diamond-like carbon) coating that reduces friction and helps prevent zirconia powder from sticking during dry milling.
They are designed for Wieland milling machines that accept φ3 mm smooth shank burs with a collet clamp. Always check your machine's spindle interface before ordering.
Use φ2.5 mm for roughing and bulk material removal, φ1 mm for semi-finishing and medium details, and φ0.6 mm for fine details, tight occlusal anatomy, and small restorations.
They are intended for pre-sintered zirconia and multi-layer zirconia in dry milling conditions. They are not for metals, glass ceramics, or wet milling.
Watch for visible wear on the cutting edges, increased milling time, rough surface finish, or chipping on zirconia margins. Replace when these signs appear rather than after a fixed number of units.
No, these are aftermarket burs manufactured by SINCEN Dental to be compatible with Wieland machines. They are not original Wieland parts.