SINCEN DLC-coated zirconia milling burs for Upcera milling machines. These burs are designed for dry milling of pre-sintered and multi-layer zirconia in dental laboratories. They produce single crowns, bridges, full-arch frameworks, and implant abutments. Available in φ0.6mm, φ1mm, and φ2mm head diameters, each with a φ4mm smooth shank for collet clamping.
| Compatible Machines | UPcera (4mm Shank), Upcera milling machine |
|---|---|
| Interface Type | φ4mm Smooth Shank |
| Material Category | Zirconia |
| Configurations | 3 |
| Order No | Specification | Head Ø | Neck | Shank | Length | Inquiry |
|---|---|---|---|---|---|---|
| φ0.6mm | φ0.6×TL10×φ4×L50 | 0.6 | 10 | 4 | 50 | 1 |
| φ1mm | φ1×TL16×φ4×L50 | 1 | 16 | 4 | 50 | 1 |
| φ2mm | φ2×TL16×φ4×L50 | 2 | 16 | 4 | 50 | 1 |
φ2mm suits roughing and bulk removal in large frameworks and full-arch cases. φ1mm suits semi-finishing of bridges and abutments. φ0.6mm suits fine finishing of occlusal surfaces, margins, and tight interproximal areas.
These burs are not for metals, glass ceramics, composites, or wet milling; they are only for dry milling of pre-sintered and multi-layer zirconia in compatible Upcera machines.
They use a φ4mm smooth shank that is collet-clamped. They do not use threaded or proprietary shank interfaces.
They are designed for Upcera milling machines that accept φ4mm smooth-shank collet-clamped tools. Check your machine's tool holder specification before ordering.
These burs are intended for dry milling of pre-sintered zirconia and multi-layer zirconia. They are not for metals, wax, PMMA, or other materials.
Use φ2mm for bulk material removal and roughing. Use φ1mm for semi-finishing and moderate detail. Use φ0.6mm for fine details, tight occlusal anatomy, and margin areas.
Look for visible edge rounding, chipping of the DLC coating, increased milling noise, higher spindle load, or surface finish deterioration on the zirconia. Replace when any of these appear.
No, these are SINCEN aftermarket burs compatible with Upcera machines. They are manufactured to fit the same φ4mm collet interface and milling envelope.
No. They are specified for dry milling only. Using coolant may affect the DLC coating and tool life.